Vertical Machining Centers Vcenter-F Series

Product Philosophy

(Fighting) Series has been developed to maximize the CP value (Cost/Performance) for end customer.

Concise Design with High-Rigidity Foundation

Inherit from the P series high-rigidity design as the foundation.

Match the necessary functions for processing according to market demand, reducing the functions that are not commonly used in general processing.

Chip Removal System Upgrade

• Standard In-machine spiral chip conveyor
• Standard Side-out spiral chip conveyor
  

Chip Removal System Upgrade

• Standard Overflow separated water tank
  

Thermal Convection Electrical Box

With the specially designed "heat dissipation channel sandwich", the heat generated by the operation of the controller is quickly discharged out of the electrical box.

• Heat dissipation channel sandwich
• The electrical box door seal design adopts the "dust-proof, waterproof and air-tight strip" design of the same specification and level of a car door.
  

Head Cutting Water System Design

• Standard Head coolant ring + lateral pipes by M-code, prevent chips from accumulating on the work table.
• Standard Air blow a by manual, optional M-code.
• Standard LED lamp above spindle, installed in front of the head spindle to directly illuminate the tool processing area with no blind spots.
  

Rigidity Stable Accuracy

The rigidity of the new A-shaped column is increased by 17%, which can avoid the vibration caused by the cutting force during cutting, and it is more powerful during heavy cutting.

Shoulder Type Tool Magazine

Shoulder type tool magazine fixed support design, the weight of the tool magazine is directly carried by the base below, and the column will not tilt due to the weight of the tool magazine and tools. The Chain-type tool holder with multiple tool counts, optional can be freely mounted without affecting the accuracy of the column.

Feature New Design

Roller linear rail uses KK-level protection, that is, two oil scrapers and a metal scraper are added on both sides of the slide rail, and a set of dust-proof sheets are also added under the slider to block foreign objects Or cut water into the slide rail.

New Sealed Bearings + 3&3 Supported for 3 Axes

New sealed bearings + 3&3 supported for 3 axes a Prevents cutting water, foreign objects from entering and causing bearing damage and grease loss.

New Design Belt-Type spindle

• Heavy and light high-power spindle design: belt-type spindle, matched with high-power output spindle, is not inferior in general heavy cutting.
• Standard BT40 taper, design offers smooth reliability at high speed.
• Spindle cooling a system (optional) removes heat efficiently and minimizes thermal deformation.
• Standard Process dynamic balance, and low vibration.
  

Optimized Configuration of Support

The stress-strain diagram analysis is increased by 30%. The support under the table of the machine with a table length of more than 1000mm must be supported by six sliding blocks, and the accuracy and processing quality are relatively stable.

When the heavy workpiece or the 4th axis rotary is placed on the high-rigidity table, the worktable don't deformed and affects the accuracy

Cutting Ability

The axis high-rigidity improved cutting ability, it can greatly improve the processing accuracy and meet the high precision requirements.